The
log is mounted so that it revolves against the blade, following
the annular growth rings. An effect similar to unwinding a roll
of paper is achieved. Rotary sliced veneer is not used for wallpaneling.
"Quarter
Slicing"
The flitch is mounted so that the growth rings strike at right angles
which produce a stripe, or straight grain, appearance.
"Rift-Cut"
The flitch is mounted so that the knife slices perpendicular to
the growth ring pattern. This type slicing is often used with Oak
flitches producing a comb effect.
"Plain
Slicing-Flat Cut"
Veneer sliced parallel to the center of the log to achieve flat-cut
veneer. The cathedrals are formed by the inner most annual growth
rings as the veneer is cut through the flitch.
"Half-Round
Slicing"
Veneer is cut on an arc roughly parallel to the center of the log
to achieve flat-cut veneer. The cathedrals can have more rounded
tops since the grain is formed by the inner most growth rings as
the veneer is cut through the flitch.
.gif){kind=small}
